Technology Tales

Adventures & experiences in contemporary technology

Manually adding an entry for Windows 7 to an Ubuntu GRUB2 menu

21st November 2010

A recent endeavour of mine has been to set up a dual-booting arrangement on my Toshiba Equium laptop with Ubuntu 10.10 and Windows 7 side by side on there. However, unlike the same attempt with my Asus Eee PC where Windows XP coexists with Ubuntu, there was no menu entry on the GRUB (I understand that Ubuntu has had version 2 of this since 9.04 though the internal version is of the form 1.9x; you can issue grub-install -v at the command line to find out what version you have on your system) menu afterwards. Thankfully, I eventually figured out how to do this and the process is shared here in a more coherent order than the one in which I discovered all the steps.

The first step is to edit /etc/grub.d/40_custom (using SUDO) and add the following lines to the bottom of the file:

menuentry 'Windows 7' {
set root='(hd0,msdos2)'
chainloader +1
}

Since the location of the Windows installation can differ widely, I need to explain the “set root” line because (hd0,msdos2) refers to /dev/sda2 on my machine. More generally, hd0 (or /dev/sda elsewhere) refers to the first hard disk installed in any PC with hd1 (or /dev/sdb elsewhere) being the second and so on. While I was expecting to see entries like (hd0,6) in /boot/grub/grub.cfg, what I saw were ones like (hd0,msdos6) instead with the number in the text after the comma being the partition identifier; 1 is the first (sda1), 2 (sda2) is the second and so on. The next line (staring with chainloader) tells GRUB to load the first sector of the Windows drive so that it can boot. After all that decoding, my final remark on what’s above is a simple one: the text “Windows 7” is what will appear in the GRUB menu so you can change this as you see fit.

After saving 40_custom, the next step is to issue the following command to update grub.cfg:

sudo update-grub2

Once that has done its business, then you can look into /boot/grub/grub.cfg to check that the text added into 40_custom has found its way in there. That is important because this is the file read by GRUB2 when it builds the menu that appears at start-up time. A system reboot will prove conclusively that the new entry has been added successfully. Then, there’s the matter of selectively to see if Windows loads properly like it did for me, once I chose the correct disk partition for the menu entry, that is!

  • All the views that you find expressed on here in postings and articles are mine alone and not those of any organisation with which I have any association, through work or otherwise. As regards editorial policy, whatever appears here is entirely of my own choice and not that of any other person or organisation.

  • Please note that everything you find here is copyrighted material. The content may be available to read without charge and without advertising but it is not to be reproduced without attribution. As it happens, a number of the images are sourced from stock libraries like iStockPhoto so they certainly are not for abstraction.

  • With regards to any comments left on the site, I expect them to be civil in tone of voice and reserve the right to reject any that are either inappropriate or irrelevant. Comment review is subject to automated processing as well as manual inspection but whatever is said is the sole responsibility of the individual contributor.